MeeGo/KernelConfig

From Joggler
(Redirected from KernelConfig)
Jump to: navigation, search

Some kernel config info to make : Media:BzImage-standalone-2.6.32-meego

Changes from MeeGo 'generic config' when running : make menuconfig

  • General : no changes
    • Enable access to .config through /proc/config.gz -> on
    • Configure standard kernel features (for small systems) -> on
  • Enable Block Layer : no changes
  • Processor type and features:
    • Single-depth WCHAN output -> on
    • Generic x86 support -> off
    • Supported processor vendors / All -> off
    • Supported processor vendors / Intel -> on
    • Maximum number of CPUs=2
    • Enable VM86 support -> off
    • Toshiba Laptop Support -> off
    • Dell Laptop Support -> off
    • Enable X86 board specific fixups for reboot -> off
    • /dev/cpu/microcode - microcode support -> off
    • /dev/cpu/*/msr - Model-specific register support -> off
    • High Memory Support & PAE -> off
    • Enable KSM for page merging -> off
    • MTRR cleanup enable value (0-1) -> 0
    • Physical address where the kernel is loaded -> 0x100000
    • Build a relocatable kernel -> MUST BE OFF
    • Alignment value to which kernel should be aligned -> 0x10000
  • Power management and ACPI options
    • Test suspend/resume and wakealarm during bootup -> on
    • ACPI (Advanced Configuration and Power Interface) Support
      • AC Adapter -> off
      • Battery -> off
      • Button -> off
      • Video -> off
      • Fan -> off
      • Dock -> off
      • Smart Battery System -> off
    • CPU Frequency scaling
      • Intel Speedstep turned on (ICH+SMI - which is used if either)
  • Bus Options
    • ISA -> off
    • PCCard (PCMCIA/CardBus) support -> off
  • Networking support
    • Networking options
      • Transformation user configuration interface -> M
      • Bluetooth subsystem support -> M
      • The IPv6 protocol -> M
    • Wireless
      • Common routines for IEEE802.11 drivers -> M
    • RF switch subsystem support -> M
  • Device Drivers
    • Block devices
      • Loopback device support -> M
    • SCSI device support
      • RAID Transport Class -> off
      • SCSI CDROM support -> M
      • SCSI generic support -> M
      • SCSI Transports / All -> off
      • SCSI low-level drivers -> off
    • Serial ATA and Parallel ATA drivers -> off
    • Multiple devices driver support (RAID and LVM) -> off
    • Fusion MPT device support -> off
    • Network device support
    • Universal TUN/TAP device driver support -> M
      • MAC-VLAN support -> off
      • PHY Device support and infrastructure -> off
      • Ethernet (100 Mbit)/ All -> off
      • Ethernet (1000 Mbit)/ All -> off
      • Ethernet (1000 Mbit)/ Realtek 8169 gigabit ethernet support -> on (Note: The Joggler has an r8168 - see Ubuntu Netbook Edition )
      • Ethernet (10000 Mbit) -> off
      • Wireless LAN / All -> off
      • Wireless LAN
        • Ralink driver support -> on
          • Ralink rt2800 (USB) support -> on
      • WiMAX Wireless Broadband devices / All -> off
      • USB Network Adapters / All -> off
      • Network console logging support -> on
      • VMware VMXNET3 ethernet -> off
    • Input device support
      • Mice
        • PS/2 mouse -> off
        • Serial mouse -> off
        • DEC VSXXX-AA/GA mouse and VSXXX-AB tablet -> off
      • Touchscreens -> FIXME
      • Miscellaneous devices -> off
    • I2C support
      • I2C device interface -> on
    • Multimedia support
    • Graphics support
      • /dev/agpgart (AGP Support) -> on
        • Intel 440LX/BX/GX, I8xx and E7x05 chipset support -> on
      • Direct Rendering Manager (XFree86 4.1.0 and higher DRI support) -> on
        • Intel IEGD -> on
      • Support for frame buffer devices
        • EFI-based Framebuffer Support -> on
      • Backlight & LCD device support -> on
        • Lowlevel LCD controls -> on
        • Generic (aka Sharp Corgi) Backlight Driver -> off
        • Openframe Backlight Driver -> on
        • Bootup logo -> on (of course!)
      • Console display driver support
        • VGA text console -> off
        • Map the console to the primary display device -> on
    • Sound card support
      • Advanced Linux Sound Architecture
        • PCI sound devices
          • Intel/SiS/nVidia/AMD/ALi AC97 Controller -> off
        • USB sound devices -> off
    • HID Devices
      • PID device support -> off
      • /dev/hiddev raw HID device support -> off
    • USB support
      • ISP116X HCD support -> off
      • ISP1362 HCD support -> off
      • OHCI HCD support -> off
      • Elan U132 Adapter Host Controller -> off
      • SL811HS HCD support -> off
      • Wireless USB Host Controller Interface (WHCI) driver -> off
      • Host Wire Adapter (HWA) driver -> off
      • USB Modem (CDC ACM) support -> off
      • USB Wireless Device Management support -> off
      • SAT emulation on Cypress USB/ATA Bridge with -> on
    • Ultra Wideband devices -> off
    • MMC/SD/SDIO card support
      • SDIO UART/GPS class -> off
      • Winbond W83L51xD SD/MMC Card Interface support -> off
      • Atmel SD/MMC Driver -> off
      • TI Flash Media MMC/SD Interface support -> off
      • X86 Platform Specific Device Drivers -> off
  • File systems
    • CD-ROM/DVD Filesystems
      • ISO 9660 CDROM file system support -> M
    • DOS/FAT/NT Filesystems
      • MSDOS fs support -> M
      • VFAT (Windows-95) fs support -> M
    • Miscellaneous filesystems
      • SquashFS 4.0 - Squashed file system support -> M
    • Network File Systems
      • NFS client support -> M
      • NFS client support for NFS version 3 -> on
      • NFS client support for NFS version 4 -> on


root=/dev/sda2 acpi=force netconsole=@10.0.0.11/,@10.0.0.111/