O2 Joggler Forum

BuZz,
Check your power supply label, +5V 4A.

Denis

I can probably knock you up a Molex to 2 pin DIN with an inline fuse if you need one. Thats if you decide to attach it to the PC. I'll try to measure the current the Joggler draws if it helps. Just checked and its about 1.2A during startup P6130097.JPG Sadly thats as far as I got as my Joggler has l...

dmp1967 your line should read "Sudo gparted" this allows gparted to write to the partition table. The line to copy the data from the image should read "Sudo dd if=/backup/mmcblk0.img of=/dev/mmcblk0 bs=1M" This assumes the mmcblk0.img has been downloaded into the /backup director...

Many thanks dw99, I just done my two Jogglers using the image you supplied. It all went well, I hadn't realised they take a while to load the software once powered up. I left them and after a minute or so the Openpeak and O2 screen brightened then went off then shortly after O2 and the blue screen a...

Just tried it and after the dd copy of mmcblk0 I loaded gparted and there was a warning against each partition "No such filesystem". I powered down and attempted to start with no luck, When I then rebooted it all looked ok other than the second partion which had been wiped. I have reformat...

I left my laptop downloading it last night.
I'll try this tonight when I get home from work.
Many Thanks,

DenisP

Many thanks dwl99, I thought the problem was down to setting mmcblk0p2 as the root.

its odd I now have two Jogglers with the same fault, one displays openpeak and freezes the other displays O2.

I had hoped it was a partion format issue or root problem.

I now have this same fault on two Jogglers, both can be partitioned and loaded with each partition image but once the Ubuntu memory stick is removed they fail to boot the O2 Sofware and trash their memory contents. From what I have gathered the boot loader sits on mmcblk0p1 and the operating system ...