Page 2 of 2
Re: Getting my Joggler to see my NAS
Posted: Sat May 05, 2012 2:21 pm
by stepoon
Ok,
Now i'm getting
mount: bad address '192.168.0.10\share'
Re: Getting my Joggler to see my NAS
Posted: Sat May 05, 2012 4:35 pm
by Wilberforce
Can you access that address from your windows pc (type it in address bar of windows explorer)? Can you ping that ip from joggler?
Re: Getting my Joggler to see my NAS
Posted: Sat May 05, 2012 6:46 pm
by stepoon
Yes when I enter that address I get the admin page for the linkstation, when I ping it through the telnet interface in winscp it pings and continues on and on? So it doesnt give a result?
Re: Getting my Joggler to see my NAS
Posted: Sat May 05, 2012 7:15 pm
by Wilberforce
If you are seeing times, for example:
64 bytes from 192.168.1.2: icmp_req=1 ttl=64 time=0.241 ms,
then they can communicate with each other. If you check your dmesg after you try and mount you may get some more clues. Other than that, if you can access it on your windows pc, I'm not too sure. Hopefully someone with more experience with cifs mounts can help you out!
Re: Getting my Joggler to see my NAS
Posted: Sat May 05, 2012 7:22 pm
by Wilberforce
a long shot is to try:
echo 0 > /proc/fs/cifs/LinuxExtensionsEnabled
before you mount.
Re: Getting my Joggler to see my NAS
Posted: Tue May 08, 2012 8:52 am
by stepoon
No still no luck at all with this - I must be doing something wrong.
I'm wondering wether the path i'm using is incorrect?
IP address is correct
i've tried everything from disk1/share/music rtc to see if it'll work but to no avail. I'm sure it's something really really simple that's stopping this!