Ubuntu Bionic for OpenFrame

[Paul Webster]

I think nginx suppprts "reload" (sighup) to detect new certificate - so can use that rather than "restart" which would mean no down time and transactions in progress could complete.

[roobarb!]

I think nginx suppprts "reload" (sighup) to detect new certificate - so can use that rather than "restart" which would mean no down time and transactions in progress could complete.

Ta, I now have certbot do this with a --post-hook, so if any certs are updated, they're reloaded automatically. Should have done that a long time ago, but I used to use wildcard certificates which require DNS confirmation, and there's no API hook for my provider. Well, none I wanted to play with anyway.

[Daedaluu5]

ive recently dabbled in modding my joggler (took way to long to get to this project) whilst i did pepper the back with quite a few custom sinks, im curious where the ubuntu sensors pick their data up from. Im seeing 50 degrees however one reading is about 10 degrees higher. Im running without the silicone pad or the plastic attempt at a heatsink, so pure copper 2mm sinks and no forced cooling.

[Daedaluu5]

So here moved the o2 Joggler by a switch and checked temps after booting and a couple of hours later...no changes...

right after boot

root@openframe:~# sensors
jc42-i2c-0-18
Adapter: SMBus SCH adapter at 0400
temp1: +48.5°C (low = +0.0°C) ALARM (HIGH, CRIT)
(high = +0.0°C, hyst = +0.0°C)
(crit = +0.0°C, hyst = +0.0°C)

tmp421-i2c-0-4c
Adapter: SMBus SCH adapter at 0400
temp1: +56.4°C
temp2: +67.4°C

coretemp-isa-0000
Adapter: ISA adapter
Core 0: +54.0°C (crit = +90.0°C)

After 2 hours:

root@openframe:~# sensors
jc42-i2c-0-18
Adapter: SMBus SCH adapter at 0400
temp1: +47.5°C (low = +0.0°C) ALARM (HIGH, CRIT)
(high = +0.0°C, hyst = +0.0°C)
(crit = +0.0°C, hyst = +0.0°C)

tmp421-i2c-0-4c
Adapter: SMBus SCH adapter at 0400
temp1: +55.2°C
temp2: +66.4°C

coretemp-isa-0000
Adapter: ISA adapter
Core 0: +52.0°C (crit = +90.0°C)

I have opened the case and left it open for a couple of hours while tinkering with it and never noticed the O2 joggler CPU getting too warm.

ive recently dabbled in modding my joggler (took way to long to get to this project) whilst i did pepper the back with quite a few custom sinks, im curious where the ubuntu sensors pick their data up from. Im seeing 50 degrees however one reading is about 10 degrees higher. Im running without the silicone pad or the plastic attempt at a heatsink, so pure copper 2mm sinks and no forced cooling.

[pete]

Not sure.