Page 1 of 1

MMC-MicroSD card question for Buzz

Posted: Fri Dec 18, 2015 2:26 pm
by pete
Trying an experiment soldered on a microSD card slot to the Openpeak tablet top device motherboard. Looking at the booting kernel it is seeing three SD controllers and only the built in 2Gb MMC.

Just experimenting and wondering a bit.

Should it see the microSD card with the current/latest Ubuntu base image?

Or are the traces on the board not connected to anything?

This is using the base EFI boot rom. I was going to try the seabios rom next.

What do ya think Buzz?

Re: MMC-MicroSD card question for Buzz

Posted: Mon Dec 21, 2015 2:49 pm
by BuZz
I don't know - which board is this ? Not sure I know it.

Either the device i unsupported in the kernel, or it's not physically connected but I don't know which.

Re: MMC-MicroSD card question for Buzz

Posted: Tue Dec 22, 2015 6:56 am
by pete
It is the Openframe 2.

Maybe I soldered the pins incorrectly?

Will post a picture of the microsd card holder soldered in to place.
openframe2.jpg
Card slot purchased - guesstimate per drawings was pin #1 is on top left. Soldered pin #9 to ground tab.
microsd-1.jpg
microsd-1.jpg (39.01 KiB) Viewed 8790 times
microsd-2.jpg
microsd-3.jpg