Discussion for non Joggler hardware / software including software for devices that share similarities with the O2 Joggler Hardware. This section has been opened for discussion of things like the settings up the EMGD drivers on other hardware using Ubuntu, as discussion of this has been banned at the official Ubuntu Forums.
Today added a second external USB port on the Openframe II (Telio / Avaya device). Works great.
This is the pin out for the 5 pin connector. Note that the square solder pad is pin #1
1 - VCC - 5VDC
2 - D - White
3 - D-+Green
4 - ID N/A Permits detection of which end of a cable is plugged in:
• "A" connector (host): connected to the signal ground
• "B" connector (device): not connected
5 - Ground
Testing this device with one SSD drive plugged into the USB port on the back and adding the USB camera on the top. The combination 802.11 / Bluetooth card works well.
root@ICS-UbuntuOF2-211:~# lsusb
Bus 001 Device 005: ID 046d:0825 Logitech, Inc. Webcam C270
Bus 001 Device 004: ID 13fd:1040 Initio Corporation
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 004 Device 002: ID 04b4:1974 Cypress Semiconductor Corp.
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 003 Device 002: ID 04cc:5556 ST-Ericsson
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 002: ID 0a5c:219a Broadcom Corp.
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
- Pete
O2 Jogglers running EFI Ubuntu / Squeezeplayer
OpenPeak Voip Telephony / Zigbee tabletops hardware modded with Seabios / RTC / Ethernet ROM edits / SSD drives running XPe for automation screens