DECT Openpeak Handset Manufacturing Tests Menu

Discussion for non Joggler hardware / software including software for devices that share similarities with the O2 Joggler Hardware. This section has been opened for discussion of things like the settings up the EMGD drivers on other hardware using Ubuntu, as discussion of this has been banned at the official Ubuntu Forums.
Post Reply
User avatar
pete
Posts: 2950
Joined: Mon Aug 01, 2011 6:33 am
Location: Time Traveler

DECT Openpeak Handset Manufacturing Tests Menu

Post by pete »

Charged up a new Openpeak DECT handset yesterday and decided to give a try to getting to the Manufacturing Tests Menu.

Easy. This is the way I did it.

1 - Settings menu I went to Settings
2 - Settings to Firmware Version
3 - Press the "#" key
4 - Press the "*" key while still pressing the "#" key
5 - remove your finger from the "#" key while still pressing the "*" key
6 - press back to go back to the Main menu
7 - press settings and now you have a new menu called Manufacturing Tests
8 - Manufacturing Tests menu shows
- DECT Settings = =>
a - CURRENT Settings
1 - Shows Mode, and a bunch of status lines.
b - Set Mode for US, EU, Brazil, LATAM, RESET Test Mode
- Enter Burn Test
- Tone 1K -> SPK
- Tone 1K -> EAR
- Tone Stop
- Loopback (MIC->SPK)
- Loopback (MIC->EAR)
- Loopback (NONE)
- Reboot
- Power OFF
- LCD Test -> goes to just a white screen
- Reset UI
- Exit Test Mode
- Pete
O2 Jogglers running EFI Ubuntu / Squeezeplayer
OpenPeak Voip Telephony / Zigbee tabletops hardware modded with Seabios / RTC / Ethernet ROM edits / SSD drives running XPe for automation screens

Auto mater
Post Reply