Search found 7 matches

by danimal
Mon Jul 31, 2017 10:26 pm
Forum: Non Joggler Software / Hardware
Topic: Cisco Openpeak 2 overvoltage
Replies: 15
Views: 24757

Re: Cisco Openpeak 2 overvoltage

So i got a new flashdrive and got the same results. I can get the bios to halt, but fs1:boot does nothing. Fs0:boot hangs or enters original OS. Its odd the flashdrive shows all sorts of life but eventually it just goes straight into factory OS. With the device on i ran nmap and found telnet wide op...
by danimal
Sat Jul 29, 2017 2:45 pm
Forum: Non Joggler Software / Hardware
Topic: Cisco Openpeak 2 overvoltage
Replies: 15
Views: 24757

Re: Cisco Openframe 2 overvoltage

Hey everyone! Sorry for the delays. I had some major projects steal my attention but I finally got back to it! So far i have been unable to get it to boot to the flash drive. I can get it to stall the post, but fs1:boot does nothing and fs0:boot goes straight into the cisco branded openpeak dash. I ...
by danimal
Thu Jul 13, 2017 8:03 pm
Forum: Non Joggler Software / Hardware
Topic: Cisco Openpeak 2 overvoltage
Replies: 15
Views: 24757

Re: Cisco Openpeak 2 overvoltage

Ok awesome! Will try it tonight! Is there a way to flash the efi so you don't have to boot that way moving forward?
by danimal
Thu Jul 13, 2017 1:37 am
Forum: Non Joggler Software / Hardware
Topic: Cisco Openpeak 2 overvoltage
Replies: 15
Views: 24757

Re: Cisco Openpeak 2 overvoltage

Years back when I first got them I had posted and someone pointed me in that direction, but I may not have been doing it right. Is there a refresher somewhere that I can review or any tips?

Thanks!
by danimal
Wed Jul 12, 2017 2:08 am
Forum: Non Joggler Software / Hardware
Topic: Cisco Openpeak 2 overvoltage
Replies: 15
Views: 24757

Re: Cisco Openpeak 2 overvoltage

Thanks for the reply!

I have not had success getting my Cisco device to boot to USB. I have tried various images as well as flash drives. Any bullet proof ways to get it to boot to USB?
by danimal
Tue Jul 04, 2017 4:17 pm
Forum: Non Joggler Software / Hardware
Topic: Cisco Openpeak 2 overvoltage
Replies: 15
Views: 24757

Cisco Openpeak 2 overvoltage

HI, I have 2 Cisco open peak 2 devices. I made the mistake of plugging the wrong PSU (12v) into them. On one of them I had not had to remove the component that protects the board against over-voltage so, I did that and now it works fine. The other however arrived defective and I removed that compone...
by danimal
Mon Sep 29, 2014 2:27 am
Forum: Non Joggler Software / Hardware
Topic: Open Frame 7e
Replies: 1
Views: 3248

Open Frame 7e

Hi Everybody! I am a long time lurker but I finally got my hands on a few so I figured I would join up! I recently acquired 3 openframe 7e devices. One of the devices is OpenFrame branded and the other two are Cisco Branded. They all appear to have been used for home energy monitoring. Upon arrival ...